& nbsp;
& nbsp; & nbsp; & nbsp; fire retardant silicone tube Caution
1, clean surface: flame retardant silicone coating composition is a clean surface cleaning to remove surface dirt and oil, keep the surface clean and dry;
2, measurement: accurate weighing A and B components (curing agent), pay attention to the pre-weighing of glue should be properly stirred to sink to the bottom of the pigments (or fillers) dispersed glue in
3, mixed plastic, should comply with the A component: B component = 1: 1 weight ratio.
4. Mixing: Press the two groups were weighed into the mixing ratio of stirred tank, so that the full mix evenly.
5, casting: the mixed rubber potting material injury within the required device, generally do not vacuum degassing, To obtain a high thermal conductivity, it is recommended vacuum degassing reperfusion. Room temperature or heat curing can be. Adhesive curing speed and curing temperature has a lot in the winter take a long time to cure, heating curing, cured for 15-20 minutes at 80 ~ 100 ℃, at room temperature normally takes about 8 hours to cure.
